Flying and driving simulators can go so far as cash will take you, and sooner or later it would find yourself being cheaper to purchase a airplane or race automobile than to maintain including capabilities to among the sim rigs we’ve seen. But it surely will also be a reasonably reasonably priced passion as properly, with entry-level parts being inside attain for a lot of. The value can drop precipitously from there too, offered some elements could be sourced and a 3D printer is made accessible, and [Jason] is demonstrating one of the lowest-cost H-shifters we’ve seen which only uses two parts at its core.
The 2 parts solely cowl the electronics for the construct, however this will get nearly the whole lot wanted for the shifter squared away. A joystick like these discovered inside many recreation controllers is paired with an Arduino Professional Micro, with a really easy wiring configuration between them. These parts are paired with a prototype 3D printed case and shift knob which supplies the H sample of alternative. From there it’s so simple as importing some readily-available firmware, which [Jason] additionally demonstrates, and which has many choices for numerous configurations of shifters.
Though this was only a prototype, it exhibits was just some off-the-shelf parts and a 3D printer can present to an reasonably priced driving sim setup. Even then a 3D printer is just not at all times crucial, like this three-pedal setup using extruded aluminum frame as a base. From there, all types of different options could be added like force feedback on the steering wheel.